3/8 Inch RSS Rugged Structural Screw by GRK Fasteners
The 3/8 Inch RSS Rugged Structural Screw by GRK Fasteners can be used on ledger boards, retailing walls, log and timber framing, or anywhere a conventional lag screw would be used.
GRKs RSS Rugged Structural Screw is made of specially hardened steel to provide you with high tensile, torque and shear strength. The sharp threads and points bite instantly into the material (including hardwood), reducing the splitting effect due to smaller shanks.
RSS screws which are 3/8 inch in size and longer have a six threaded CEE thread that enlarges the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increasing the screws drawing strength. The CEE thread also reduces the likelihood of splitting the wood and the friction on the screw shank which can result in lowering the driving torque.
The round head with built-in shield (washer type head) has no sharp edges such as on conventional lag screws. The added shoulder (nominal diameter) underneath the washer has the ability to center the RSS screw in pre-drilled hardware like hinges and connector plates. Short lengths of the RSS may also be used to install wire diamond mesh for stucco buildings.
No Pre-Drilling (unless required by material)
W-Cut thread design with ZipTip
Hardened steel with Climatek coating
Note: #30 Starhead Bit sold separately.
|Head Type||Round washer head|
|Screw Length||6 in, 7-1/4 in, 8 in, 10 in and 12 in|
|Material Type||Hardened steel with Climatek coating|
6 = 50 Pro Pack and 300 Pack
|Included Accessories||None (#30 Starhead Bit sold separately)|
|Warranty||View GRK Warranty Information|