Self-tapping
W-Cut thread design, ZipTip
Climatek coated
May be used for Lag screw replacement

Bits NOT included with purchase - 5/16 screws take a #30 bit
(see related products to the right)

GRKs RSS Rugged Structural Screw is made of specially hardened steel to provide you with high tensile, torque and shear strength. The sharp threads and points bite instantly into the material (including hardwood), reducing the splitting effect due to smaller shanks.

RSS screws which are 3"1/8 and longer have a six threaded CEE thread that enlarges the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increasing the screws drawing strength. The CEE thread also reduces the likelihood of splitting the wood and the friction on the screw shank which can result in lowering the driving torque.

Our round head with built-in shield (washer type head) has no sharp edges such as on conventional lag screws. The added shoulder (nominal diameter) underneath the washer has the ability to center the RSS screw in pre-drilled hardware like hinges and connector plates. Short lengths of the RSS may also be used to install wire diamond mesh for stucco buildings.

The #30 Star Drive will deliver approximately 650 lbs of energy, eliminating the need to drill a pilot hole.

The RSS screw is the only lag screw replacement of its kind.
RSS Structural Screw Test Data

GRK Fasteners utilizes strict quality control procedures. Every batch of screws produced is independently random sampled and quality controlled to the highest standards.